To Next PageTo Next Page
Need help?Do you have a question about the Lenze Smart Motor m300 MSEMA Series and is the answer not in the manual?
General| Protection Class | IP65 |
|---|---|
| Efficiency Class | IE3 |
| Frequency | 50/60 Hz |
| Cooling Method | Surface cooling |
| Communication | CANopen |
| Mounting | Foot, Flange |
| Ambient Temperature | -25 to +40 °C (depending on derating) |
Observe warning symbols for hot surfaces, high leakage current, and ESD.
Component for horizontal material handling, must be used as specified.
Check bearings for noise, remove dirt deposits to prevent overheating.
Overview of optional features like brake resistors, cooling, and motor connections.
Details on M12 control connections, QUICKON mains connection, and brake resistor ports.
Conformity, approvals, protection ratings, leakage current, and insulation requirements.
Specifications for torque, speed, power, voltage, current, and brake resistors.
Safety warnings for hazardous voltage, ESD, and humidity on the device.
Specific safety requirements for installation complying with UL and CSA standards.
Details on electrical connections for single drives, including wiring diagrams.
Requirements for adapting the motor using NFC-capable smartphone or PC.
Overview of parameter settings, including PIN management and standard configurations.
How the drive behaves during errors and warnings, including fault reading and reset.
Table of fault codes, possible causes, and remedies for various error conditions.
