Commissioning and operation
Important notes
8
37
Lenze • BA 33.0006 • 5.1
8 Commission ing and operation
8.1 Important notes
For trial run without output elements, lock the featherkey. Do not deactivate the
protective devices, not even in a trial run.
Check the correct operation of the brake before commissioning motors with brakes.
8.2 Before switching on
Note!
Before switch-on, you must ensure that the motor starts with the
intended direction of rotation.
Lenze motors rotate CW (looking at the driven shaft) if a clockwise
three-phase field L1 U1, L2 V1, L3 W1 is applied.
Before initial commissioning, before commissioning after an extended standstill
period, or before commissioning after an overhaul of the motor, the following must be
checked:
• Measure the insulation resistance, in case of values 1kper volt of rated
voltage, dry the winding.
• Have all screwed connections of the mechanical and electrical parts been firmly
tightened?
• Is the unrestricted supply and removal of cooling air ensured?
• Has the PE conductor been connected correctly?
• Have the protective devices against overheating (temperature sensor e valuation)
been activated?
• Is the controller correctly parameterised for the motor?
( Controller operating instructions)
• Are the electrical connections o.k.?
• Does the motor connection have the correct phase sequence?
• Are rotating parts and surfaces which can become very hot protected against
accidental contact?
• Is the contact of good electrical conductivity if a PE connection on the motor
housing is used?
To Next Page
Loading...
Need help?
General