Handling
T
ransport, storage
Comply with the instrucons for transport, storage and proper handling. Ensure careful han-
dling and avoid mechanical overloading. Do not bend any components during transport and
handling and do not change the insulaon clearances. Do not touch any electronic compo-
nents and contacts. Do not damage or destroy any electrical components as doing so can
cause a health hazard!
The storage locaon must be free of vibraons and shocks (V
e
< 0.2 mm/s) in order to avoid
roller-bearing damage when equipment is at a standsll.
When the product is being stored, temperature changes with condensaon formaon are to
be avoided.
Shas and bright surfaces are delivered with protecon against corrosion.
Installaon
The technical data and supply condions can be obtained from the nameplate and the docu-
mentaon. They must be strictly observed.
You must install the product in accordance with the regulaons indicated in the associated
documentaon. Adhere to the climac condions as indicated in the technical data.
Ambient media − especially chemical aggressive media − can aack sha sealing rings and
paintwork (general plascs). Abrasive media can damage the sha sealing rings. If this hap-
pens, consult the responsible branch oce of Lenze.
Electrical connecon
When working on energised products, comply with the applicable naonal accident preven-
on regulaons.
The electrical installaon work must be carried out according to the appropriate regulaons
(e. g. cable cross-secons, fuses, PE connecon). Addional informaon can be obtained
from the documentaon.
The documentaon contains instrucons on EMC-compliant installaon. Comply with these
instrucons in the case of CE-labelled products as well. The manufacturer of the system or
machine is responsible for adherence to the limits required in connecon with EMC laws.
operaon
Where appropriate, you must equip the system/machine with addional monitoring and pro-
tecve devices. Comply with the safety regulaons and other regulaons applicable at the
place of operaon.
Aer the product has been separated from the supply voltage, refrain from immediately
touching the live parts and power connecons of the device because capacitors may have
been charged. Take note of the corresponding informaon plates on the product.
Deposited dirt or dust prevent head dissipaon (cooling). Remove any such deposits at regular
intervals.
Maintenance and servicing
The products are maintenance-free if the prescribed condions of use are complied with.
Disposal
The products and accessories must be properly disposed of in accordance with the applicable
regulaons. The products contain raw materials that can be recycled such as metals, plascs
and electronic components.
Project planning
Sa
fety instrucons
Handling
22
To Next Page
Loading...
