Letscom ID205S - Disassembling and Assembling Your Watch

- 2 -
When the watch shows that the battery is low,
connect the watch to a USB port with
5V-500mA.
While the watch charges, there is a battery
progress bar on the screen and you can tap
the touch key to check the battery level.
Remove the watch from the power supply once fully charged.
● USB charger requirement: DC USB port (5V-500mA)
● Charging time: Approximately 2 hours
Disassembling / Assembling Your Watch
Disassembly
1. To remove the wristbands, turn over the watch and find the
quick-release lever.
2. While pressing the quick-release lever inward, gently pull the
wristband away from the watch to release it.