What to do if receiver and transmitter channels are mismatched on Leuze electronic MLC 520 EX?
To resolve the issue where the receiver is set to C1 and the transmitter to C2 on your Leuze electronic Lighting Equipment, set both the transmitter and receiver to the same transmission channel and ensure they are correctly aligned.
What to do if ambient temperature is too high for Leuze electronic MLC 520 EX Lighting Equipment?
If the ambient temperature is too high for your Leuze electronic Lighting Equipment, ensure correct environmental conditions.
What to do if reset button actuation duration exceeded on Leuze electronic MLC 520 EX Lighting Equipment?
If the actuation duration (2.5 min) has been exceeded for the reset button or the cable is short-circuited on your Leuze electronic Lighting Equipment, press the reset button. If the restart is unsuccessful, check the wiring of the reset button.
What to do if Leuze electronic Lighting Equipment shows internal error?
If your Leuze electronic Lighting Equipment shows an internal error, and a restart fails, replace the device.
How to troubleshoot interference detected on plug pin 4 in Leuze electronic Lighting Equipment?
If interference is detected on plug pin 4 of your Leuze electronic Lighting Equipment, check the wiring.
What to do if restart interlock operating mode changed during operation of Leuze electronic MLC 520 EX Lighting Equipment?
If the restart interlock operating mode changed during operation of your Leuze electronic Lighting Equipment, check the correctness of the selected operating mode, correct the operating mode if required, and restart.
How to replace failed Leuze electronic Lighting Equipment receiver?
If your Leuze electronic Lighting Equipment receiver has failed, replace the device.
How to fix a defective transmitter in Leuze electronic MLC 520 EX?
If the transmitter of your Leuze electronic Lighting Equipment is defective, replace it.
What to do if the control circuit is open in Leuze electronic MLC 520 EX Lighting Equipment?
If the control circuit is open in operating mode 1, 2, or 3 on your Leuze electronic Lighting Equipment, close the input circuit with the correct polarity and timing.
How to troubleshoot transmitter without supply voltage in Leuze electronic Lighting Equipment?
If the transmitter of your Leuze electronic Lighting Equipment lacks supply voltage, check the power supply unit and the electrical connection. If necessary, replace the power supply unit.
General| Brand | Leuze electronic |
|---|---|
| Model | MLC 520 EX Series |
| Category | Lighting Equipment |
| Language | English |
To Next Page
