4.7.4 SNMP Setting
In brief, SNMP, the Simple Network Management Protocol, is a protocol designed to give a user the capability
to remotely manage a computer network by polling and setting terminal values and monitoring network
events.
Enable SNMP
You must check either Local or Remote or both to enable SNMP function. If Local is checked, this device will
response request from LAN. If Remote is checked, this device will response request from WAN.
Get Community
Setting the community of GetRequest your device will response.
Set Community
Setting the community of SetRequest your device will accept.
WAN Access IP Address
If the user wants to limit to specific the IP address, please input in the item. The default 0.0.0.0 and means
every IP of Internet can get some information of device with SNMP protocol.
45
To Next Page
Loading...
