FAQ
Restore Factory Default
In some cases, system does not respond to any operation, this process gets the unit back to initial status,
so that it can be reconfigurable for up and running again.
To restore factory default, please follow the steps:
1. Unplug the power jack to turn off the camera
2. Insert a pin into the reset hole pressed the reset button and keep it pressed until instructed to
release.
3. Plug in the power jack to turn on the camera. The power LED will start flashing in a short
while.
4. Release the pin when the LED starts quick flashing. The device should be set back to factory
default.
To Next Page
Loading...
