LevelOne USB-0301 User Manual

USB 2.0 Ethernet Adapter User’s Manual
10
on Mac

Operating Systems
After booting up your Mac OPERATING SYSTEMSX system, plug USB dongle
onto the USB port of your Mac OPERATING SYSTEMSX system and refer to
below figure to add a new “USB Ethernet” network interface and then press the
[Apply] button to take effect the new network interface..
Also navigate to System Preference>Network, please click on Renew DHCP
Lease and Apply Now as following to verify the installation of driver and Ethernet
Adapter.

LevelOne USB-0301 Specifications

Network Specifications

network standards	IEEE 802.3: 10Base-T, IEEE 802.3u: 100Base-T
data transfer rates	Ethernet: 10Mbps (Half/Full Duplex), Fast Ethernet: 100Mbps (Half/Full Duplex)
network interface	Female RJ45 jack

Power

power consumption	850mW
power management	Suspend mode, hibernation mode

Operating Environment

operating system support	Windows® 2000, XP, Vista™, Windows®7; Mac OS X 10.x
operating temperature	0°C to 70°C

System Memory

RAM	Embedded 20KB SRAM for RX packet buffering and 20KB SRAM for TX packet buffering

Weight and Dimensions

dimensions	66 mm x 22 mm x 15 mm
weight	25g