Need help?Do you have a question about the LevelOne WAP-6015 and is the answer not in the manual?
Connect the power adapter or use an Ethernet cable to power on the LevelOne access point.
Set up the access point via a switch or a WAC controller for management.
Configure PC for automatic IP acquisition and TCP/IP settings to ensure network communication.
Launch browser, enter AP IP address, and use default credentials to log into the Web GUI.
Connect the power adapter or use an Ethernet cable to power on the LevelOne access point.
Set up the access point via a switch or a WAC controller for management.
Configure PC for automatic IP acquisition and TCP/IP settings to ensure network communication.
Launch browser, enter AP IP address, and use default credentials to log into the Web GUI.
General| Ethernet Ports | 1 x 10/100/1000 Mbps |
|---|---|
| Power over Ethernet (PoE) | 802.3af |
| Antenna Type | Internal |
| Operating Mode | Access Point, Client, WDS, Repeater |
| Operating Temperature | 0°C to 40°C |
| Storage Temperature | -20°C to 70°C |
| Wireless Standards | IEEE 802.11b/g |
| Frequency Band | 2.4 GHz / 5 GHz |
| Security | WEP, WPA, WPA2, 802.1X |
| Power Supply | 12V DC, 1A |
| Humidity | 10% to 90% (non-condensing) |
To Next Page