Need help?Do you have a question about the LevelOne WAP-6202 and is the answer not in the manual?
The Power LED indicates when the AP is powered on.
WLAN LED blinks during wireless data transmission or reception.
USB port charges external devices (5V, 1A).
The Phone port is used to connect a telephone.
PoE port connects power via a PoE switch or injector.
LAN port connects to network devices like switches.
RJ11 block connects to a 4-core telephone cable.
Press Reset for 5s to restart and reset to factory defaults.
Configure the access point via a direct connection to a switch or router with your computer.
Configure the access point managed by a WAC-1000/WAC-1001 controller from your computer.
Ensure your PC obtains an IP address automatically for communication with the AP.
Open a web browser and enter the AP's default LAN IP address (192.168.1.253).
Enter 'admin' for username and 'admin' for password to access the AP's Web GUI.
The Power LED indicates when the AP is powered on.
WLAN LED blinks during wireless data transmission or reception.
USB port charges external devices (5V, 1A).
The Phone port is used to connect a telephone.
PoE port connects power via a PoE switch or injector.
LAN port connects to network devices like switches.
RJ11 block connects to a 4-core telephone cable.
Press Reset for 5s to restart and reset to factory defaults.
Configure the access point via a direct connection to a switch or router with your computer.
Configure the access point managed by a WAC-1000/WAC-1001 controller from your computer.
Ensure your PC obtains an IP address automatically for communication with the AP.
Open a web browser and enter the AP's default LAN IP address (192.168.1.253).
Enter 'admin' for username and 'admin' for password to access the AP's Web GUI.
General| Brand | LevelOne |
|---|---|
| Model | WAP-6202 |
| Category | Wireless Access Point |
| Language | English |
To Next Page