Need help?Do you have a question about the LevelOne WAP-6110 and is the answer not in the manual?
Provides basic instructions for physically connecting the Wireless Gateway to power, network, and computers.
Verifies the network connection and device functionality after setup using LEDs and web access.
Configures fundamental wireless parameters like SSID, band, mode, and channel.
Details how to set up wireless security using WEP or WPA to prevent unauthorized access.
Sets up WPA/WPA2 security using Personal mode with a pre-shared key or passphrase.
Enables MAC address filtering (Allow Listed/Deny Listed) for network access control.
Information and setup for Wi-Fi Protected Setup (WPS) for easy wireless connection.
Configuration page for the local area network settings of the Access Point.
Procedure to modify the IP address and subnet mask for the device's LAN port.
Step-by-step guide for downloading and installing firmware updates manually.
Procedure to reset the device's configuration to its original factory default settings.
Instructions for changing the default username and password for device access.
Provides solutions for common problems related to LEDs, Internet access, and web page display.
Explains how to use IP utilities like 'ping' and 'nslookup' to diagnose network issues.
Provides basic instructions for physically connecting the Wireless Gateway to power, network, and computers.
Verifies the network connection and device functionality after setup using LEDs and web access.
Configures fundamental wireless parameters like SSID, band, mode, and channel.
Details how to set up wireless security using WEP or WPA to prevent unauthorized access.
Sets up WPA/WPA2 security using Personal mode with a pre-shared key or passphrase.
Enables MAC address filtering (Allow Listed/Deny Listed) for network access control.
Information and setup for Wi-Fi Protected Setup (WPS) for easy wireless connection.
Configuration page for the local area network settings of the Access Point.
Procedure to modify the IP address and subnet mask for the device's LAN port.
Step-by-step guide for downloading and installing firmware updates manually.
Procedure to reset the device's configuration to its original factory default settings.
Instructions for changing the default username and password for device access.
Provides solutions for common problems related to LEDs, Internet access, and web page display.
Explains how to use IP utilities like 'ping' and 'nslookup' to diagnose network issues.
General| Frequency Band | 2.4 GHz |
|---|---|
| Maximum Data Rate | 300 Mbps |
| Power over Ethernet | Yes (802.3af) |
| Operating Temperature | 0°C to 40°C |
| Wireless Standards | IEEE 802.11n |
| Security | WEP, WPA, WPA2 |
| Ethernet Ports | 1 x 10/100 Mbps |
| Operating Modes | Access Point, WDS, Repeater |
| Storage Temperature | -20°C to 70°C |
To Next Page
