16
Configure Slave AP via WEC Button
Step 1
Check 2.4GHz LED of Access Point which acts as Master Mode. It should be Green. If not,
please use WEC button to switch into Master Mode.
Step 2
Check 2.4GHz LED of Access Point which acts as Slave Mode. It should be Amber. If not,
please use WEC button to switch into Slave Mode.
Step 3
Click WEC Button (about 1second) of master AP and any slave AP as one pair
simultaneously
Step 4
WiFi LED of Master and Slave AP will flash and Negotiate WiFi Profile Configuration. This
Process will finish within 30~60 sec. Then WiFi LED will be Solid.
※If Negotiation failed or Master or Slave AP don’t existed, WiFi LED will Flash 2 min
then will be Solid. Please try again
To Next Page
Loading...
