Levitronix LEVIFLOW LFSC-i19X

Questions and Answers

J
jgatesAug 8, 2025
What to do if Levitronix Measuring Instruments show incorrect flow measurement?
- E
  Eduardo BarberAug 8, 2025
  If your Levitronix Measuring Instruments display an incorrect flow measurement, it could be due to several reasons: - The measuring tube may not be completely filled with liquid. - There might be disturbances in the measuring path caused by bubbles or solid substances. - Excessive noise from nearby devices like motors or high-voltage cables could be interfering. - Cables might be incorrectly connected or damaged. - The calibration set may not be properly selected. Check these aspects to resolve the issue.
H
hbrownAug 13, 2025
Why does the flow indication not match the real flow in Levitronix LEVIFLOW LFSC-i19X Measuring Instruments?
- B
  Blake ReedAug 13, 2025
  The flow indication might not match the real flow in Levitronix Measuring Instruments due to wrong parameter settings or excessive bubbles or solids in the measurement path. To resolve this: - Check if the parameters in the converter are set correctly. - Inspect the flow path for stagnating solids. - Inspect the measurement path for excessive bubbles.
C
Connor SmithAug 18, 2025
What to do if Levitronix LEVIFLOW LFSC-i19X indicate above full scale flow or the flow signal is unstable?
- S
  Sandra DuncanAug 18, 2025
  If Levitronix Measuring Instruments indicate a flow above full scale or the flow signal is unstable, it could be due to wrong parameter settings, or excessive bubbles or solids in the measurement path. You should: - Check if the parameters in the converter are set correctly. - Inspect the flow path for stagnating solids. - Inspect the measurement path for excessive bubbles.
B
brandithompsonAug 22, 2025
How to correct incorrect flow measurement after zeroing Levitronix LEVIFLOW LFSC-i19X?
- K
  Kevin SanchezAug 23, 2025
  If you're experiencing incorrect flow measurement after zeroing your Levitronix Measuring Instruments, it might be due to a non-ideal situation during the zeroing process. Ensure the circuit is filled with liquid and that the flow is actually zero. Then, perform the zero adjustment again.
G
griffinstevenAug 27, 2025
What does yellow/red blinking at 1 Hz mean on Levitronix Measuring Instruments?
- R
  Renee ButlerAug 27, 2025
  A yellow/red blinking light at 1 Hz on Levitronix Measuring Instruments indicates a non-resolvable error, such as an active bootloader or a defect in the primary image. Try power cycling the device, resetting it via the interface, or downloading the correct firmware using Levitronix® Service Software. If the issue persists, the sensor may need replacement.
C
crystal81Sep 2, 2025
Why is zero flow indicated at a flow level below the cut-off value on Levitronix LEVIFLOW LFSC-i19X?
- Y
  youngmichaelSep 2, 2025
  If zero flow is indicated at a flow level below the cut-off value on your Levitronix Measuring Instruments, the standard cut-off value may not be adequate for your specific application. Adapt a lower cut-off value with Levitronix® Service Software.