Why doesn't the flow indication match the real flow in my Levitronix Measuring Instruments?
If the flow indication doesn't match the real flow, it could be due to several reasons. First, verify that the parameters in the converter are set correctly. Second, inspect the flow path for any stagnating solids. Finally, check the measurement path for excessive bubbles.
What to do if Levitronix LEVIFLOW LFIF indicate above full scale flow or the flow signal is unstable?
If your Levitronix Measuring Instruments indicate flow above full scale or the flow signal is unstable, there are a few things to check. Begin by ensuring that the parameters in the converter are correctly configured. Also, inspect the flow path for any accumulation of solids and examine the measurement path to ensure there are no excessive bubbles.
How to fix zero flow indication on Levitronix LEVIFLOW LFIF Measuring Instruments when there is flow?
If your Levitronix Measuring Instruments indicate zero flow even when there is flow in the hydraulic circuit, it could be due to a few reasons. First, check if the parameters have been set to the optimal values, and that the mechanical setup of the sensor is correct, and the zero adjustment wasn't performed under flow conditions. Also, check if the flow direction is correct. Finally, redo zeroing at 0 lpm.
What to do if Levitronix LEVIFLOW LFIF Measuring Instruments indicate zero flow below the cut-off value?
If your Levitronix Measuring Instruments indicate zero flow at a flow level below the cut-off value, it might be that the standard cut-off value is not adequate for your application. Adapt a lower cut-off value using the LEVIFLOW® Configuration Software.
Covers warnings about opening the housing, hazardous voltage, and toxic chemicals.
Details the standard components, accessories, and general technical specifications of the flowmeter.
Provides detailed dimensional drawings for the LFIF-06 flowmeter and its associated extension cables.
Outlines the standard and configurable parameters for the flowmeter, including software requirements.
Covers electrical interface items, preparation, and overview for installation.
Provides step-by-step instructions for electrical installation, including critical safety warnings.
Details flowmeter data configuration and provides instructions for mechanical and hydraulic installation.
Explains general timing parameters for operation and the meaning of various LED indicators.
Describes operation with PLC interface, RS485, and LEVIFLOW® Configuration Software.
Lists common issues, causes, countermeasures, and troubleshooting using configuration software.
Details regulatory compliance with European Directives and explains safety symbols and signal words.
General| Accuracy | ±1% of reading |
|---|---|
| Power Supply | 24 VDC |
| Wetted Materials | PTFE |
| Output Signal | 4-20 mA, 0-10 V, RS-485 |
| Process Connections | 1/4" to 1" NPT, Tri-Clamp, Flange |
To Next Page
