11
Figure 2.4
Figure 2.5
Figure 2.6
Important Tips
Your humidifier must have the correct level
of water in the base chamber to work
properly. If there is too much water in the
base chamber, the humidifier cannot create
mist.
• Never pour water directly into the
base chamber. Only add water to the
water tank. [Figure 2.4] The humidifier
will automatically release the correct
amount of water into the base chamber.
• Avoid moving or shaking the humidifier.
[Figure 2.5] This may cause the water
tank to release too much water into the
base chamber.
• Before moving the humidifier, turn it o,
unplug it, and remove the water tank.
• If your humidifier doesn’t produce mist
correctly, check the max water line to
see if there is too much water in the
base chamber. Pour out extra water if
water is over the max line. [Figure 2.6]
Note: The max water line is only for this purpose.
Do not pour water into the base chamber.
02.02_ML_HTHOHIHC03DL_Classic200_UltrasonicCoolMistHumidifier.indd 1102.02_ML_HTHOHIHC03DL_Classic200_UltrasonicCoolMistHumidifier.indd 11 2/10/20 12:58 PM2/10/20 12:58 PM