8
GETTING S TA R T E D
1st
2nd
3rd
Carbon
Filter
HEPA
Filter
1. Open the back cover of the air purifier and remove both
filters from their plastic packaging [Figure 1.1].
2. Reinstall the filters, first with the activated carbon filter
(black) followed by the HEPA filter (white). Make sure the
pull tabs on both filters are facing outward. [Figure 1.2]
Figure 1.1
Figure 1.3
Figure 1.4
Figure 1.2
3. Replace the back cover by aligning the bottom portion
of the cover with the inlets on the bottom of the
housing. Make sure that the piece at the bottom of the
cover comes into contact with safety switch. [Figure 1.3]
4. Slowly close the cover by aligning the top portion of
the back cover with the inlets at the top of the opening.
[Figure 1.4]
To Next Page
Loading...
