12
USING YOUR HUMIDIFIER (CONT.)
You can set a timer between 1 and 12 hours.
Auto Mode uses the humidifier’s sensor to
automatically adjust the mist level (or turn
it o) to maintain a comfortable level of
humidity.
While the humidifier is plugged in, it will
remember your settings (except Timer)
when turned o, and will resume these
settings when turned back on.
The humidifier will automatically turn o
when all of the water in the tank has been
diused. will show on the display until
more water is added to the water tank.
[Figure 3.1]
The display will automatically dim after 10
seconds of inactivity. To turn o the display,
press and hold for 3 seconds. To turn
the display back on, press any button,
except .
The mineral absorption pads help prevent
mineral buildup (scale) inside the humidifier,
especially around the heating plate.
Timer
Auto Mode
Memory Function
Automatic Shutoff
Turning Off the Display
Absorption Pads
Note: You can also press on the
remote control to turn the display on/o.
Note: To purchase more pads, see
page 17.
Figure 3.1
• Press repeatedly to choose a time
in increments of 1 hour. When you stop
pressing , the display will flash 3
times and the timer will start.
• The humidifier will automatically power
o once the timer is finished.
• To cancel a timer, press repeatedly
or press and hold until the display
reads “-:--”.
• Press to turn Auto Mode on/o.
• The timer and warm mist setting can be
used with Auto Mode.
• Changing the mist level using will
cancel the Auto Mode function.