EasyManua.ls Logo

Levoit LV600S Series - Getting Started; Initial Setup and Placement

Levoit LV600S Series
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8
GETTING STARTED
1. Remove all packaging.
2. Clean the water tank and water tank
cover before first use.
Note: Check to make sure that the
water filter is correctly in place. If not,
then rotate the filter clockwise to secure
it in place.
Note: The humidity sensor and an air
inlet are both located inside the aroma
box. Placing the humidifier away from
walls will also ensure that the inlet and
sensor function properly.
Figure 1.1
3. Choose a hard, flat location for the
humidifier at least 12 inches / 30 cm away
from any walls. The surface must be
water-resistant. [Figure 1.1]
Do not place the humidifier directly
on floors, carpets, or rugs.
4. Mist should be directed away from walls,
furniture, bedding, and appliances. Avoid
letting too much mist fall on the side of
the humidifier with the aroma box, as this
may interfere with the sensor inside the
aroma box.
12 in /
30 cm
12 in /
30 cm

Other manuals for Levoit LV600S Series

Related product manuals