Levoit True HEPA Vital 100 Series - Maintenance Procedures: Filter Reset; Resetting the Filter Indicator; Maintenance Procedures: Filter Cleaning; Cleaning the Washable Pre-Filter

10
Resetting the Check Filter
Indicator
Reset the Check Filter Indicator when:
A. lights up.
1. Replace the air filter (see page 11).
2. Turn on the air purifier.
3. Press and hold for 3 seconds.
4. will turn o when successfully
reset.
B. The filter was changed before
lit up.
1. Press and hold for 3 seconds.
This will turn on
.
2. Press and hold again for 3
seconds.
3. will turn o when successfully
reset.
Cleaning the Filter
The Pre-Filter should be cleaned once a
month to increase eciency and extend the
life of your filter.
1. Remove the filter from the housing and
clean the Pre-Filter with a soft brush or
vacuum hose to remove hair, dust, and
large particles.
2. Carefully peel the Pre-Filter away from
the True HEPA and Activated Carbon
Filters. [
Figure 2.1 ]
3. Gently wash the Pre-Filter under running
water. Dry completely before placing it
back on the velcro tape.
4. Replace filter in housing.
Figure 2.1
Filter
When to
Clean
When to
Replace
Pre-Filter
Vacuum
every 2–4
weeks
6–8 months
Wash every
1–2 months
True HEPA
& Activated
Carbon
Filter
Do not
clean
Note: Do not clean the True HEPA and
Activated Carbon Filters.
CARE & MAINTENANCE (CONT.)