6
USING YOUR AIR
PURIFIER
1. Plug in and tap to turn the air purifier
on/o. The fan will start on level I.
2. Optionally, tap to cycle fan speeds
between I, II, and III.
General Operation
Note:
• The indicators are not buttons and
cannot be used to change the fan
speed.
• The fan speed indicators will light up
when active.
• Fan speed III is the loudest, but cleans
air the quickest.
• For best results, or to address a
specific air quality issue such as
smoke, run the air purifier at high
speed (level III) for 15–20 minutes
before using a lower speed.
• To eectively clean air, keep windows
and doors closed while the air purifier
is on.
Memory Function
When the air purifier is plugged in, it will
remember its previous fan speed setting.
Note:
The air purifier will not remember
timers.
GETTING STARTED (CONT.)
3. Replace the back cover by lining up the
cover’s feet with the matching slots on
the bottom of the housing. [
Figure 1.3
]
4. Push the cover closed.
5. Place the air purifier on a hard, flat
surface. Leave 15 inches / 38 cm of
clearance to allow air to pass through
the air inlets on the sides. [
Figure 1.4
]
Figure 1.3
Figure 1.4
38 cm /
15 in
38 cm /
15 in
To Next Page
Loading...
Need help?
General
