Lexicon MPX 100 - System Mode Parameter Overview; Adjustable Parameter List Introduction

System parameters and MIDI dumps
are activated in System mode. To enter this
mode, press and hold Bypass for approxi-
mately 2 seconds. The Bypass and Store
LEDs will blink slowly to indicate you are in
System mode.
The adjustable parameters available in
this mode are shown in the chart on the
following page.
13
System Mode
Turn the VARIATION knob to select a
parameter. Press Store to toggle the state of
the parameter, or to execute a MIDI dump.
The Edit LED will show the current state of
each parameter.
When you have finished editing param-
eters and are ready to resume normal opera-
tion, return the VARIATION knob to its prior
setting, or you will load a new program based
on its position when you exit System Mode.
(The Tap LED will light when VARIATION
matches its prior setting.)
To exit System Mode, Press Bypass. If
you have changed any System parameters,
the Store LED will flash rapidly.