56 USB port [x] disabled
Try one or more of the following:
• Touch Continue to clear the message.
The printer discards any data received through the USB port.
• Make sure the USB Buffer menu is not set to Disabled.
57 Configuration change, some held jobs were not restored
Something has changed in the printer to invalidate the held jobs. Possible changes include:
• The printer firmware has been updated.
• Paper input options needed for the print job were removed.
• The print job was created using data from a device in the USB port and the device is no longer in the USB port.
• The printer hard disk contains print jobs that were stored while installed in a different printer model.
Touch Continue to clear the message.
58 Input config error
1 Turn the printer off.
2 Unplug the power cord from the wall outlet.
3 Check if all tray configurations are correct. Remove unnecessary trays if needed.
4 Connect the power cord to a properly grounded electrical outlet.
5 Turn the printer back on.
58 Too many bins attached
1 Turn the printer off.
2 Unplug the power cord from the wall outlet.
3 Remove the additional bins.
4 Connect the power cord to a properly grounded electrical outlet.
5 Turn the printer back on.
58 Too many disks installed
1 Turn the printer off.
2 Unplug the power cord from the wall outlet.
3 Remove the excess disks.
4 Connect the power cord to a properly grounded electrical outlet.
5 Turn the printer back on.
Troubleshooting
191
To Next Page
Loading...
