Lexmark Confidential
14
900.30 Error After Pressing “Cancel Jobs” Button
• A 900.30 Firmware Error is caused by pressing the “Cancel
Jobs” button after receiving a fax with a blank Remote
Station ID.
• This error can also occur if a fax with a blank Remote
Station ID is held in the Fax Job Queue.
• Try power cycling the printer to resolve the error.
• If the fax with the blank Remote Station ID is still in the Fax
Job Queue, however, this is stored on the Hard Drive so the
Fax Job Queue will need to be cleared in Diagnostic Mode.
• Updating the printer to the latest level of code should
resolve the issue.
X925 MFP only
To Next Page
