Lexmark E120 - Light Sequence

Understanding the Operator Panel
2
Light sequence
Primary
light
sequence
Secondary
light
sequence
Message
Ready / Data Error Ready / Data Error
Ready / Power Saver
Busy
Waiting
Cancel job / Reset printer
Flushing buffer
Invalid engine code (Ready / Data light blinks once)
Not ready (Ready / Data light blinks once)
Printing font list or menu settings page
Programming engine code or system code
Restoring factory defaults
Cartridge region mismatch (Ready / Data light blinks four times)
Change cartridge / Defective cartridge (Ready / Data light blinks three times)
Open door (Ready / Data light blinks once)
Complex page (Ready / Data light blinks three times)
ENA connection lost (Ready / Data light blinks five times)
Insufficient collation area (Ready / Data light blinks three times)
Load media (Ready / Data light blinks once)
Print side two of a duplex job (Ready / Data light blinks once)
Ready / Data light on =
Ready / Data light blinking =
Error light on =
Error light blinking =