7
Insert the tray.
8
If a different type of paper was loaded than the type previously
loaded in the tray, change the Paper Type setting.
Note: The difference between the standard 250-sheet tray and the
optional 250- and 550-sheet trays is that the standard tray
accommodates up to 150 sheets of A6-size paper, so the width
guides slide farther to the center of the tray.
Using the manual feeder
The manual feeder is located inside the manual feeder door of the
printer and can feed only one sheet of paper at a time. You can use
the manual feeder to quickly print on paper types or sizes that are
not currently loaded in the tray.
1
Open the manual feeder door.
2
When the light is lit, load the paper faceup into the center
of the manual feeder.
Notes:
•
Load letterhead faceup, with the top of the sheet entering
first.
•
Load envelopes with the flap side down and with the
stamp area as shown.
3
Feed paper into the manual feeder only to the point where its
leading edge can contact the paper guides.
4
Adjust the paper guides to the paper width.
Warning—Potential Damage: Do not force the paper into the
feeder. Forcing the paper causes jams.
Using the standard exit bin and
paper stop
The standard exit bin holds up to 150 sheets of 20 lb paper. It
collects print jobs facedown. The standard exit bin includes a
paper stop that keeps paper from sliding out the front of the bin
as it stacks. The paper stop also aids in neater stacking of the paper.
Loading paper and specialty media
3
To Next Page
Loading...
Need help?
General
