Try one of the following:
•
Remove Tray 1.
•
Open the front door, and then remove the photoconductor kit
and toner cartridge unit.
•
Remove Tray 2.
251.yy Paper jam
- On
- On
- On
- On
Remove the jam from the manual feeder.
Clearing jams behind the
photoconductor kit and toner
cartridge
1
Push the release button, and then lower the front door.
2
Lift and pull the unit containing the photoconductor kit and
the toner cartridge out of the printer. Set the unit aside on a
flat, clean surface.
Warning—Potential Damage: Do not touch the
photoconductor on the underside of the photoconductor kit.
Use the cartridge handle whenever you are holding the
cartridge.
CAUTION—HOT SURFACE: The inside of the printer
might be hot. To reduce the risk of injury from a hot
component, allow the surface to cool before touching.
3
Remove the jammed paper.
Note: If the paper is not easy to remove, then open the rear
door to remove the paper.
4
Align and reinstall the unit.
5
Close the front door.
6
Press to continue printing.
Clearing jams from the
standard exit bin
A duplex print job was sent to the printer using a paper size not
supported for duplex printing. A sheet is jammed in the standard
exit bin.
Clearing jams
7
To Next Page
Loading...
Need help?
General
