How to add a memory card
50
How to install options
How to add a memory card
The system board has one connector for an optional memory card. The Lexmark E340 and the Lexmark E342n can
support up to 128MB of additional memory (for a total of 160MB).
CAUTION: If you are installing a memory card after setting up the printer, turn the printer off, and unplug the
power cord before continuing.
Note: Memory options designed for other Lexmark printers may not work with your printer.
1 Access the system board (see How to access the system board).
2 Push open the latches on both ends of the memory connector.
3 Unpack the memory card.
Warning: Memory and flash memory cards are easily damaged
by static electricity. Touch something metal, such as the
printer frame, before you touch a memory card.
Avoid touching the connection points along the edge of the card.
4 Align the notches on the bottom of the card with the notches
on the connector.
5 Push the memory card firmly into the connector until the
latches on either end of the connector snap into place.
It may require some force to fully seat the card.
6 Make sure each latch fits over the notch on each end of the
card.
7 Close the side cover.
8 Close the rear exit.
9 Close the front cover.
10 See Recognizing installed options.
To Next Page
Loading...
