Lexmark Interpret S400 - Page 20

5 Complete the initial printer setup.
C HANGE THE LANGUAGE USING A BUTTON COMBINATION ( IF YOU CANNOT READ THE CURRENT
LANGUAGE
)
1 Turn the printer off.
Note: If you have set the Power Saver timeout in the Setup menu, then press and hold
for three
seconds to turn off the printer.
2 Press and hold down and , and then press and release to turn the printer on.
Note: Do not release
and until Language Selection appears on the display, indicating
that the printer has been reset.
3 Complete the initial printer setup.
Printhead errors
If the "Before you troubleshoot" checklist does not solve the problem, then try the following:
R EMOVE AND REINSERT THE PRINTHEAD
1 Open the printer and lift the latch.
2
W
F
I
I
P
R
I
N
T
I
N
G
2 Remove the printhead.
Warning—Potential Damage: Do not touch the printhead nozzles.
3 Wipe the printhead contacts using a clean, lint-free cloth.
4 Reinsert the printhead, and then close the latch until it clicks.
5 Close the printer.
Note: If removing and reinserting the printhead does not resolve the error, then contact technical support.
20