Lexmark MS317 - Connecting MS312 to a Wireless Network Using the Printer Software

Notes:
• The IP address appears as four sets of numbers separated by periods, such as 123.123.123.123.
• If you are accessing a proxy server, then temporarily disable it to load the Web page correctly.
4 Access the WPS settings. For more information, see the documentation that came with your access
point.
5 Enter the eight‑digit PIN, and then save the setting.
Connecting MS312 to a wireless network using the printer software
Notes:
• Make sure that the printer is turned on.
• Make sure that a wireless network adapter is installed in your printer and working properly. For
information, see the instruction sheet that came with the adapter.
Using the Wireless Setup Utility (Windows only)
1 Check if the printer software is already installed.
2 Use the search command on the Start menu to locate Printer Home.
3 Open Printer Home, and then click Settings > Wireless Setup Utility.
4 Follow the steps on the computer screen.
Using the Wireless Setup Assistant (Macintosh only)
The Wireless Setup Assistant lets you:
•
Configure
the printer to join an existing wireless network.
• Add a printer to an existing ad hoc network.
• Change the wireless settings after installation.
• Install the printer on additional network computers.
Installing the Wireless Setup Assistant
1 Go to the Lexmark support Web site at http://support.lexmark.com.
2 Download the latest Wireless Setup Assistant application.
3 Double‑click the downloaded software installer package.
4 Follow the instructions on the computer screen.
Launching the Wireless Setup Assistant
Notes:
• Make sure the printer is turned on.
Additional printer setup 23