Use To
Timeouts
Hibernate Timeout on Connection
Hibernate
Do Not Hibernate
Set the printer to Hibernate mode even if there is an active
Ethernet connection.
Note: Do Not Hibernate is the factory default setting.
Timeouts
Screen Timeout
15–300
Set the amount of time in seconds before returning the control
panel to a Ready state.
Note: 30 is the factory default setting.
Timeouts
Print Timeout
Disabled
1–255
Set the amount of time in seconds the printer waits to receive
an end‑of‑job message before canceling the rest of the job.
Notes:
• 90 is the factory default setting.
• When the timer expires, any partially printed page still in
the printer is printed, and then the printer checks to see
if any new print jobs are waiting.
• Print Timeout is available only when using PCL
emulation. This setting has no eect on PostScript
emulation print jobs.
Timeouts
Wait Timeout
Disabled
15–65535
Set the amount of time in seconds the printer waits for
additional data before canceling a print job.
Note: 40 is the factory default setting.
Error Recovery
Auto Reboot
Reboot when idle
Reboot always
Reboot never
Max Auto Reboots
1–20
Set the printer to restart when an error occurs.
Notes:
• Reboot always is the factory default setting for Auto
Reboot.
• 2 is the factory default setting for Max Auto Reboots.
Print Recovery
Auto Continue
Disabled
5–255
Let the printer automatically continue printing from certain
oine situations when these are not resolved within the
specified time period.
Note: Disabled is the factory default setting.
Print Recovery
Jam Recovery
On
O
Auto
Specify whether the printer reprints jammed pages.
Note: Auto is the factory default setting. The printer reprints
jammed pages unless the memory required to hold the
pages is needed for other printer tasks.
Understanding the printer menus 104