Use To
Eco-Mode
O
Energy
Energy/Paper
Paper
Minimize the use of energy, paper, or specialty media.
Note:
O
is the factory default setting. This resets the printer
to its factory default settings.
Quiet Mode
O
On
Minimize the printer noise.
Note: O is the factory default setting.
Run Initial setup
Ye s
No
Run the setup wizard.
Paper Sizes
US
Metric
Specify the unit of measurement for paper sizes.
Notes:
• US is the factory default setting.
• The initial setting is determined by your country or
region selection in the initial setup wizard.
Timeouts
Sleep Mode
Disabled
1–120
Set the amount of time in minutes the printer waits after a job
is printed before it goes into a reduced power state.
Notes:
• 20 is the factory default setting.
• Disabled appears only when Energy Conserve is set to
O.
• The maximum amount of time is increased to 240
minutes when Energy Conserve is set to O.
• Lower settings conserve more energy, but may require
longer warm‑up times.
• Select a high setting if the printer is in constant use.
Under most circumstances, this keeps the printer ready
to print with minimum warm‑up time.
Timeouts
Print with Display O
Allow printing with display o
Display on when printing
Print a job with the display turned o.
Note: Display on when printing is the factory default setting.
Timeouts
Hibernate Timeout
Disabled
1–3 hours
6 hours
1–3 days
1–2 weeks
1 month
Set the amount of time the printer waits before it enters
Hibernate mode.
Note: 3 days is the factory default setting.
Understanding the printer menus 103
To Next Page
Loading...
Need help?
General
