Lexmark MS517 - Additional Printer Setup; Installing Internal Options

Additional printer setup
Installing internal options
CAUTION—SHOCK HAZARD: If you are accessing the controller board or installing optional hardware
or memory devices sometime after setting up the printer, then turn the printer o, and unplug the power
cord from the electrical outlet before continuing. If you have any other devices attached to the printer,
then turn them o as well, and unplug any cables going into the printer.
Warning—Potential Damage: Controller board electronic components are easily damaged by static
electricity. Touch a metal surface on the printer before touching any controller board electronic components
or connectors.
Available internal options
• DDR3 DIMM
• Flash memory
– Fonts
– Firmware
• Forms Barcode
• Prescribe
• IPDS
• PrintCryption
• Hard disk
*
• Internal Solutions Ports (ISP)
*
– Parallel 1284‑B interface
– MarkNet N8130 10/100 fiber interface
– RS‑232‑C serial interface
*
This internal option is available only in the MS610de printer model.
Installing an optional card
CAUTION—SHOCK HAZARD: If you are accessing the controller board or installing optional hardware
or memory devices sometime after setting up the printer, then turn the printer o, and unplug the power
cord from the electrical outlet before continuing. If you have any other devices attached to the printer,
then turn them o as well, and unplug any cables going into the printer.
Additional printer setup 12