Lexmark MS610 Series - Installing a Memory Card

4 Push the card firmly into place.
Warning—Potential Damage: Improper installation of the card may cause damage to the card and the
controller board.
Note: The entire length of the connector on the card must touch and be
flush
against the controller
board.
5 For the MS510dn, MS517dn, MS610dn, and MS617dn printer models, close the controller board access door.
For the MS610de printer model, close the controller board shield, and then close the access door.
Note: When the printer software and any hardware options are installed, add the options manually in the
print driver to make them available for print jobs. For more information, see
“Adding available options in the
print driver” on page 29.
Installing a memory card
CAUTION—SHOCK HAZARD: If you are accessing the controller board or installing optional hardware
or memory devices sometime after setting up the printer, then turn the printer o, and unplug the power
cord from the electrical outlet before continuing. If you have any other devices attached to the printer,
then turn them o as well, and unplug any cables going into the printer.
Additional printer setup 14