4 Prepare the paper or specialty media for loading.
• Flex sheets of paper back and forth to loosen them. Do not fold or crease the paper. Straighten the edges on a level
surface.
• Hold transparencies by the edges. Straighten the edges on a level surface.
Note: Avoid touching the printable side of the transparencies. Be careful not to scratch them.
• Flex the stack of envelopes back and forth to loosen them. Straighten the edges on a level surface.
5 Load the paper or specialty media.
Note: Slide the stack gently into the multipurpose feeder until it comes to a stop.
• Load only one size and type of paper or specialty media at a time.
• Make sure the paper fits loosely in the multipurpose feeder, lies flat, and is not bent or wrinkled.
• There are different ways of loading letterhead depending on whether an optional staple finisher is installed or not.
Printing Guide
Page 14 of 16
To Next Page
Loading...
