Notes:
• Make sure that all paper fragments are removed.
• If the 3000‑sheet tray is installed, then slide the tray to the
right to open the door.
7 Close door C.
[x]‑page jam, press latch to access area
G. Leave paper in bin. [40y.xx]
1 Remove all paper from the staple finisher bin.
2 Press the latch and slide the staple finisher to the left, and then
remove the jammed paper.
Notes:
• Make sure that all paper fragments are removed.
• If necessary, turn spinner wheel G1 downward to feed
jammed paper into the finisher bin, and then remove the
paper.
3 Slide the finisher back into place.
4 Open door C, and then remove the jammed paper.
CAUTION—HOT SURFACE: The inside of the printer might
be hot. To reduce the risk of injury from a hot component,
allow the surface to cool before touching it.
Notes:
• Make sure that door C does not hit any cable attached to the
printer.
• Make sure that all paper fragments are removed.
• If the 3000‑sheet tray is installed, then slide the tray to the
right to open the door.
5 Close door C.
13
To Next Page
Loading...
