Lexmark MS911 - Loading Letterhead; Loading Prepunched Paper; Linking and Unlinking Trays

2 Adjust the guide to match the size of the paper you are loading.
3 Flex the sheets of paper back and forth to loosen them, and then
fan them. Do not fold or crease the paper. Straighten the edges on
a level surface.
4 Load the paper.
• Load only one size and type of paper.
Loading letterhead
Without an optional finisher With an optional finisher
One‑sided printing
Note: For long-edge
orientation, load letterhead
facedown with the header on
the left side of the feeder.
One‑sided printing
Note: For long-edge
orientation, load letterhead
facedown with the header on
the right side of the feeder.
Two‑sided printing
Note: For long-edge
orientation, load letterhead
faceup with the header on the
right side of the feeder.
Two‑sided printing
Note: For long-edge
orientation, load letterhead
faceup with the header on the
left side of the feeder.
Loading prepunched paper
One‑sided printing Two‑sided printing
• Load envelopes with the flap side down.
Warning—Potential Damage: Never use envelopes with
stamps, clasps, snaps, windows, coated linings, or self‑stick
adhesives. These envelopes may severely damage the
printer.
• Make sure that the paper is below the maximum fill line.
Overfilling may cause paper jams.
5 From the control panel, set the paper size and paper type in the
Paper menu to match the paper loaded in the feeder.
Linking and unlinking trays
Linking and unlinking trays
1 Open a Web browser, and then type the printer IP address in the
address field.
3