Lexmark MX710 Series - Some Held Jobs Were Not Restored

Scanner jam, remove all originals from the scanner [2yy.xx]
Remove the jammed paper from the scanner.
Scanner jam, remove jammed originals from the scanner [2yy.xx]
Remove the jammed paper from the scanner.
Scanner maintenance required soon, use ADF Kit [80]
Contact customer support, and then report the message. The printer is scheduled for maintenance.
Scanner maintenance required, use ADF Kit [80]
The printer is scheduled for maintenance. For more information, go to the Lexmark support Web site at
http://support.lexmark.com or contact your service representative, and then report the message.
Serial port [x] disabled [56]
Try one or more of the following:
• From the printer control panel, touch Continue to clear the message.
The printer discards any data received through the specified serial port.
• Make sure Serial Buer is not set to Disabled.
• From the printer control panel, set Serial
Buer
to Auto in the Serial [x] menu.
SMTP server not set up. Contact system administrator.
From the printer control panel, touch Continue to clear the message.
Note: If the message appears again, then contact your system support person.
Some held jobs were not restored
From the printer control panel, touch Continue to delete the indicated job.
Note: Held jobs that are not restored remain in the printer hard disk and are inaccessible.
Standard network software error [54]
Try one or more of the following:
• From the printer control panel, touch Continue to continue printing.
• Turn o the printer, and then turn it back on.
• Update the network firmware in the printer or print server. For more information, visit the Lexmark
support Web site at
http://support.lexmark.com or contact customer support, and then report the
message.
Troubleshooting 282