PCL
2-40
ESC
&l#L
0Off
1On(Default)
Skip Perforation
Perforation area includes the area from the bottom margin of the
current page to the top margin of the next page. When skipping
perforations, a line feed past the bottom margin ejects a page and
places the cursor at the top margin of the next page.
ESC
&k#H
# = number of 1/120 inch increments
(Valid to 4 decimal places)
Set Horizontal Motion Index (HMI)
Sets the width of all characters for fixed-space fonts. Sets only the
width of the space for proportional spaced fonts.
ESC
&l#C
# = number of 1/48 inch increments
(Valid to 4 decimal places)
Default = 8
Set Vertical Motion Index (VMI)
Sets Vertical Motion Index in 1/48 inch increments. The VMI
determines the vertical distance between lines.
Notes:
• For some printers, you can change the default VMI from the printer
operator panel or through MarkVision by using the
Lines Per Page
menu item. Refer to your printer user documentation for more
information.
• Use of this command alters any previous Set Line Spacing
command settings.
ESC
&l#D
1 1 line/inch
2 2 lines/inch
3 3 lines/inch
4 4 lines/inch
6 6 lines/inch (Default)
8 8 lines/inch
12 12 lines/inch
16 16 lines/inch
24 24 lines/inch
48 48 lines/inch
Set Line Spacing (Alternative Method)
Specifies VMI in lines per inch.
Notes:
• For some printers, you can change the default VMI from the printer
operator panel or through MarkVision by using the
Lines Per Page
menu item. Refer to your printer user documentation for more
information.
• Unsupported values are ignored.
• Use of this command alters any earlier VMI setting.
ESC
&a#G
0NextSide
1FrontSide
2BackSide
Duplex Page Side Selection
Specifies which physical page side to print next when duplex printing.
Note: When the duplex option is not installed, this command causes a
conditional page eject.
Table 2-21: Page Control (Continued)
Command / Parameters Function / Result
To Next Page
Loading...
Need help?
General