7
IPDS Printer and Host Setup Guide AS/400 and iSeries LAN Printing Using the Printer Standard Network Port or MarkNet Internal Print Server
Note 1: IPDS pass through may be set to *YES. This may increase job performance. Selecting *YES may
change the fonts downloaded from the host and change paper jam recovery action between the host
and printer.
Note 2: Refer to
“Printer and Host Timeout Values” [page 34]
for information on selecting the Release
Timer value.
Note 3:
Use outline fonts controls the type of fonts downloaded to the printer. When set to *YES,
outline fonts are downloaded to the printer. When set to
*NO, raster fonts are downloaded to the
printer. When the outline or raster fonts are marked eligible for capture on the host, the host will send
fonts which can be captured at the printer.
Example PSFCFG with parameters to change shown in bold.
PSF configuration PSFCFG >
IPDSPRT
(Note: IPDSPRT is a user defined name.)
Library............................... >
QGPL
User resource library list.. USRRSCLIBL *JOBLIBL
Device resource library list DEVRSCLIBL *DFT
+ for more values
IPDS pass through..................... IPDSPASTHR >
*NO <note1>
Activate release timer................ ACTRLSTMR *NORDYF
Release timer......................... RLSTMR >
*SEC15 <note2>
Restart timer......................... RESTRTMR *IMMED
APPC and TCP/IP retry count........... RETRY 15
Delay time between APPC retries....... RETRYDLY 90
Acknowledgement frequency............. ACKFRQ 100
Printer response timer................ PRTRSPTMR *NOMAX
Generate PDF output................... PDFGEN *NONE
Text 'description'.................... TEXT >
'IPDS Printer'
(Note: ‘IPDS Printer’ is user defined text.)
Additional Parameters
Automatic session recovery: AUTOSSNRCY
Enabled........................... *NO
Message option....................
Blank page............................ BLANKPAGE *YES
Page size control..................... PAGSIZCTL *NO
Resident fonts........................ RESFONT *YES
Resource retention.................... RSCRET *YES
Edge orient........................... EDGEORIENT *NO
Use outline fonts..................... USEOUTLFNT
*NO
<note3>
PSF defined option.................... PSFDFNOPT *NONE
Font substitution messages............ FNTSUBMSG *YES
Capture host fonts at printer......... FNTCAPTURE
*NO
<note4>
Font resolution for formatting........ FNTRSL *SEARCH
Font mapping table.................... FNTTBL *NONE
Library.............................
Cut sheet emulation mode.............. CSEMODE *NONE
Use DBCS simulation fonts............. MAPIGCFNT *NO
Replace............................... REPLACE *YES
Authority............................. AUT *LIBCRTAUT
To Next Page
Loading...
Need help?
General
