If manualfeed or ManualFeed is true, then the printer prompts you to load the requested size manually. If no manual
feed exists on the printer, then a rangecheck error message is issued.
The envelope tray the printer selects when it receives an envelopetray operator is listed in “Envelopetray operator
selections” on page 17. These operators are equivalent to executing the following PostScript emulation sequence:
<</PageSize [x y] /ImagingBBox null /Policies<</PageSize 0>> >>
setpagedevice
where x y are the PageSize in points.
Envelopetray operator selections
= Supported
X = Not supported
Tray operators
Printer models
Operator Tray selected (corresponding image size is set) X548de, X548dte
110x220envelopetray tray with 110 x 220‑size envelopes
dlenvelopetray tray with 110 x 220‑size envelopes
162x229envelopetray tray with 162 x 229‑size envelopes
c5envelopetray tray with 162 x 229‑size envelopes
176x250envelopetray tray with 176 x 250‑size envelopes
b5envelopetray tray with 176 x 250‑size envelopes
3.875x7.5envelopetray tray with 3.875 x 7.5‑size envelopes
monarcenvelopetray tray with 3.875 x 7.5‑size envelopes
3.875x8.875envelopetray tray with 3.875 x 8.875‑size envelopes
4.125x9.5envelopetray tray with 4.125 x 9.5‑size envelopes
com10envelopetray tray with 4.125 x 9.5‑size envelopes
otherenvelopetray tray with other size envelopes
PostScript (PS) emulation 17
To Next Page
Loading...
