i Pull and then rotate the green rectangular knob
counterclockwise to firmly secure the top paper guide.
1
2
j Reinstall the fuser unit:
1 Align the fuser unit using the handholds on each side, and
then place it back into the printer.
2 Turn the screws clockwise to fasten the fuser securely.
4 Close the front door, and then close the top access cover.
5 From the printer control panel, touch Continue, jam cleared.
202–203 paper jams
If the jammed paper is visible in the standard exit bin, then firmly grasp
the paper on each side, and then gently pull it out.
Note: Make sure all paper fragments are removed.
Paper jam in the fuser area
1 Open the printer top access cover.
CAUTION—HOT SURFACE: The inside of the printer might
be hot. To reduce the risk of injury from a hot component,
allow the surface to cool before touching it.
2 Open the front door.
Warning—Potential Damage: To avoid overexposing the
photoconductor units, do not leave the front door open for
more than 10 minutes.
3 Determine where the jammed paper is located, and then remove
it:
a If the jammed paper is visible under the fuser, then firmly grasp
the paper on each side, and then gently pull it out.
Note: Make sure all paper fragments are removed.
b If the jammed paper is visible at the top paper guide in the fuser
assembly, then firmly grasp the paper on each side, and then
gently pull it out.
Note: Make sure all paper fragments are removed.
c If the jammed paper is not visible, then remove the fuser unit:
1 Turn the screws on the fuser counterclockwise to loosen
them.
2 Using the handholds on each side, lift and pull the fuser out
of the printer.
CAUTION—HOT SURFACE: The fuser might be
hot. To reduce the risk of injury from a hot
component, allow the surface to cool before
touching it.
22
To Next Page
Loading...
