Lexmark X792 - Page 61

Lexmark C792/X792 Color Product Study Guide Rev 2.1
For Training Purposes Only 6/24/2011
53
- Check the skew measurements in this table to see if the printer meets the spec.
Note: Is the Skew on the Simplexed or a Duplexed side? Look at the section Image Orientation in the
Tray found earlier in this guide to decide which side is skewed.
Skew Specification - Simplex
Paper Size
Simplex
Skew
Specification
Left Vertical –
Paper Length
(L2-L1)
Right Vertical –
Paper Length
(R2-R1)
Top – Paper
Width
(T2-T1)
Bottom – Paper
Width
(B2-B1)
Letter
(216mm × 279mm)
0.005mm/mm
≤ 1.4mm
1
≤ 1.4mm
1
≤ 1.0mm
1
≤ 1.0mm
1
A4
(210mm × 297mm)
0.007mm/mm
≤ 2.1mm
2
≤ 2.1mm
2
≤ 1.4mm
2
≤ 1.4mm
2
1, 2
Calculated by taking the width or length of the paper (in millimeters) and multiplying it by the Simplex Skew Specification:
Example using Letter Size Paper:
Paper Width (mm) x Simplex Skew Specification (mm/mm) = Acceptable Skew Amount for Top/Bottom
216mm (letter paper width) x 0.005mm/mm = 1.0mm
Paper Length (mm) x Simplex Skew Specification (mm/mm) = Acceptable Skew Amount for Left/Right
279mm (letter paper length) x 0.005mm/mm = 1.0mm
Skew Specification - Duplex
Paper Size
Duplex Skew
Specification
Left Vertical –
Paper Length
(L2-L1)
Right Vertical –
Paper Length
(R2-R1)
Top – Paper
Width
(T2-T1)
Bottom – Paper
Width
(B2-B1)
Letter
(216mm × 279mm)
0.007mm/mm
≤ 2.0mm
1
≤ 2.0mm
1
≤ 1.5mm
1
≤ 1.5mm
1
A4
(210mm × 297mm)
TBD TBD TBD TBD TBD
1
Calculated by taking the width or length of the paper (in millimeters) and multiplying it by the Duplex Skew Specification:
Example using Letter Size Paper:
Paper Width (mm) x Duplex Skew Specification (mm/mm) = Acceptable Skew Amount for Top/Bottom
216mm (letter paper width) x 0.005mm/mm = 1.0mm
Paper Length (mm) x Duplex Skew Specification (mm/mm) = Acceptable Skew Amount for Left/Right
279mm (letter paper length) x 0.005mm/mm = 1.0mm