Warning—Potential Damage: System board electronic components are easily damaged by static electricity. Touch
something metal on the printer before touching any system board electronic components or connectors.
1 Access the system board.
for more information, see
“Accessing the system board” on page 35
2 Remove the metal bracket from the printer hard disk using a flathead screwdriver.
3 Connect the printer hard disk interface cable into the receptacle of the ISP board.
4 Reattach the system board cover.
Removing a printer hard disk
The printer hard disk is preinstalled in this device.
Note: This task requires a flathead screwdriver.
Additional printer setup 44
To Next Page
Loading...
