Lexmark X954 - Page 54

54
5.2.1.1 Lexmark C792, Lexmark X792 and Lexmark 6500e Optional Finisher
The optional finisher supports only one staple position. You can not physically change the position of the
staple. The printer automatically rotates text before stapling when the finisher is installed. If necessary,
reformat your job on the host with a different text orientation to avoid stapled sets that are hard to read.
Refer to your printer or finisher documentation to determine the finishing support and staple location for
various paper sizes. Finishing functions may not be applied to all paper sizes.
Parameters in the printer file that affect stapling
Printer device type
*IPDS
Output bin
For Lexmark C792 and Lexmark X792 use 2.
For Lexmark 6500e use 2 if only optional finisher is installed.
For Lexmark 6500e use 3 if optional finisher is installed on top of output
expander.
Corner staple
*DEVD
or
*TOPLEFT
The *DEVD staple position is the top left. Specifying any other setting may cause an exception to be
reported to the host.
Drawing of staple placement
Text
Text text text text
text
text.
Short-edge fed
paper, leading edge
Text shown with
0 degree
rotation
specified in
IPDS job
*DEVD
*TOPLEFT