4 Remove the screw (C).
C
5 Remove the fuser actuator.
Installation note: To test if the actuator is properly installed, push, and then release the actuator (A). The
actuator should bounce back.
A
Reverse solenoid removal
1 Remove the left cover. See “Left cover removal” on page 209.
2 Remove the right cover. See “Right cover removal” on page 223.
3 Remove the rear cover. See “Rear door and cover removal” on page 273.
7017-2xx, -4xx, -6xx
Parts removal
216
To Next Page
Loading...
