Bottom removals
Power supply removal
CAUTION—SHOCK HAZARD: The low-voltage power supply (LVPS) may have residual voltage present.
To avoid the risk of electrical shock, do not touch its circuit components. Only handle it by its metal
housing.
1 Remove the rear cover. See “Rear door and cover removal” on page 273.
2 Disconnect the cable (A), and then remove the screws (B).
BBA
3 Position the printer on its right side.
Warning—Potential Damage: The ADF might swing open while you position the printer on its side.
7017-2xx, -4xx, -6xx
Parts removal
260
To Next Page
Loading...
