Fuser removal
CAUTION—HOT SURFACE: The inside of the printer might be hot. To reduce the risk of injury from a hot
component, allow the surface to cool before touching it.
1 Remove the right cover. See “Right cover removal” on page 223.
2 Remove the scanner rear covers. See “Scanner rear covers removal” on page 272.
3 Remove the rear cover. See “Rear door and cover removal” on page 273.
4 Disconnect the two cables (A), and then remove the two screws (B).
A
A
B B
5 Open the controller board access cover, and then disconnect the fuser cable from the board.
6 Remove the fuser.
Redrive gear assembly removal
1 Remove the top cover. See “Top cover removal” on page 276.
2 Remove the left cover. See “Left cover removal” on page 209.
3 Remove the redrive assembly. See “Redrive assembly removal” on page 274.
4 Remove the two screws (A), and then detach the reverse solenoid.
Note: Do not disconnect the reverse solenoid cable from the controller board.
7017-2xx, -4xx, -6xx
Parts removal
275
To Next Page
Loading...
