3
Slide the width guide to the correct position for the size of the
paper you are loading.
Note: Use the paper size indicators on the bottom of the tray
to help position the guides.
4
Prepare the paper or specialty media for loading.
•
Flex the sheets back and forth to loosen them, and then
fan them. Do not fold or crease the paper. Straighten the
edges on a level surface.
•
Hold transparencies by the edges, and then fan them.
Straighten the edges on a level surface.
Note: Avoid touching the printable side of the
transparencies. Be careful not to scratch them.
•
Flex the stack of envelopes back and forth to loosen them,
and then fan them. Straighten the edges on a level surface.
5
Load the paper or specialty media.
Note: Slide the stack gently into the multipurpose feeder
until it comes to a stop.
•
Load only one size and type of paper or specialty media at
a time.
•
Make sure the paper fits loosely in the multipurpose feeder,
lies
flat,
and is not bent or wrinkled.
One‑sided (simplex) printing Two‑sided (duplex) printing
ABC
12
To Next Page
Loading...
Need help?
General
