Note: 110V units print letter size while 220V units print A4 size.
3 Register the flatbed:
a Open the ADF, and then remove the flatbed glass cushion (A).
b Place the glass cushion on the flatbed scanner glass with its Velcro pads facing up, and aligning it squarely in
the corner where the green arrow is located.
c Lower the ADF down onto the scanner glass, and then raise the ADF up again to pick up the glass cushion.
d Run your hand across the glass cushion to make sure it is attached.
4 Place the target page face down on the scanner glass.
Note: Make sure the paper is properly aligned on the scanner glass. The back left corner of the paper should
align squarely with the green arrow on the scanner glass.
5 Lower the ADF down and then select Quick Copy Test.
7463
Repair information
409
To Next Page
Loading...
