Board housing removal
Note: When removing the board housing, the controller board will remain attached to the board housing.
1 Remove the right cover. See “Right cover removal (MX71x)” on page 438.
2 Remove the rear lower cover. See “Rear lower cover removal” on page 551.
3 Remove the LVPS. See “LVPS removal” on page 445.
4 Remove the left cover. See “Left cover removal (MX71x)” on page 416.
5 Disconnect all of the cables from the controller board.
6 Remove the five screws (A).
7 Remove the board housing.
7463
Repair information
431
To Next Page
Loading...
